Page 36 - Bridgemate II Manual

Chapter 4: Server functions 30

Restarting Bridgemate network

The wireless network can be restarted from the server using the function Server à Force restart. Use
this function to solve wireless communication problems between multiple Bridgemates and the server.

Resetting the server

The Reset server menu function resets the entire server and deletes all entered data. To avoid
accidental resets, you will be asked to enter a verification number which is displayed on the screen.

Note: If the server is not connected to the power adapter and/or is not fitted with batteries, all data will
be lost. It is therefore not necessary to reset the server before disconnecting it from the power source
or after connecting it to the power source.

Setting the region

The Bridgemate II score system communicates over a predetermined frequency spectrum. The
permitted frequency differs per region. Three regions are currently supported: Europe, North America
and Australia / New Zealand. When first launching Bridgemate Control Software, you will be asked to
select your region. The server will select the corresponding frequency spectrum to communicate with
the Bridgemates. Remember to set the corresponding region in the Bridgemate setup menu.

If you want to change the regional settings of the server, go to Server à Region selection.

The “Current region” function displays the current region. Select the new region and press “Set”. The
new region has now been set.

Setting the channel

The server and the Bridgemates must be set to the same channel to communicate with each other. To
set the channel on the server, use the Server à Channel selection menu.

The “Current channel” function displays the current channel. Select the new channel and press “Set”.
The new channel has now been set.