History changes Bridgemate firmware: ------------------------------------ Server firmware: ---------------- Release: 1.2.6 Date: November 14th, 2007 Requires: Bridgemate firmware version 2.2.2a Bugs solved: - Pair numbers higher than 63 were not correctly displayed in the TD-menu option 2 Overview of previous results. - NP (not played) was not displayed in the TD-menu option 2 Overview of previous results. - When two scores were registered on one board and one of the two scores was a PASS, the player's overview of results showed an * for both scores. Bridgemate firmware: -------------------- Release: 2.3.2a Date: September 17th, 2008 Requires: Server firmware version 1.2.6 - "Enter declarer" message appears when user doesn't enter declarer after contract, but hits OK directly instead. Release: 2.3.1a Date: May 29th, 2008 Requires: Server firmware version 1.2.6 New: - Optionally players can set the section and table number of the Bridgemate themselves when session starts. This eliminates the requirement to place the Bridgemate on the correct table. Release: 2.2.2a Date: November 14th, 2007 Requires: Server firmware version 1.2.6 Bugs solved: - Pair numbers higher than 63 were not correctly displayed in the TD-menu option 2 Overview of previous results. - NP (not played) was not displayed in the TD-menu option 2 Overview of previous results. - When two scores were registered on one board and one of the two scores was a PASS, the player's overview of results showed an * for both scores. Release: 2.2.1a Date: November 30th, 2006 Requires: Server firmware version 1.2.3 New: - "System not activated yet" text is shown when a Bridgemate cannot connect to the server. - American method of recording results has been added. - Option to disallow blank entry of member numbers.